A-A-50382
Measurements and weight – The finished anklets shall conform to the requirements stated below and tested in accordance with the stated test methods of FED-STD-191. All relaxed measurements shall be made with the anklets laid out flat, under no tension as shown in Figure 1.
|
See Figure 1 |
Leg (A) |
Foot (B) |
Ribbed Top (C) |
|
Relaxed Inches |
|||
|
Medium |
8 to 9 |
8 to 9-1/2 |
5-1/2 to 6-1/2 |
|
Large |
9 to 10 |
9-1/2 to 10-1/2 |
6-1/2 to 7 |
|
Stretched Inches (minimum) – Test Method 7560 1/ |
|||
|
Medium |
12 |
||
|
Large |
13-1/2 |
||
|
Conditioned weight/dozen ounces (minimum) |
|||
|
Medium |
15 |
||
|
Large |
18 |
||
1/ The lengthwise stretch of the socks shall be measured using the sock measuring machine apparatus and measurement of specimen procedure specified in Test Method 7560 of FED-STD-191. The measurement shall be taken to the nearest 0.1 inch and the measured stretch “foot length” obtained in accordance with this procedure shall be considered as the lengthwise foot stretch.
Workmanship. After completion, the anklets shall be thoroughly cleaned and all foreign matter removed.
Product demonstration model – Offerers are required to submit two pairs of anklets of their intended production and style. Product demonstration model will consist of units independently developed. Product demonstration models will be analyzed and evaluated by the Government. Evaluation criteria and basis for award are contained in the solicitation. Product demonstration models will be retained by the Government. One product demonstration model approved by DPSC under the resultant contract will serve as a manufacturing standard for the corresponding production items delivered under this contract. Offerers are advised that the product demonstration model does not relieve the successful offerer of his responsibility to perform in accordance with the Commercial Item Description specified above.
Responsibility for inspection – The supplier is responsible for assuring the Product conforms to the requirements. Anklet lots will be inspected to determine conformance with the Commercial Item Description and the successful offerer’s technical proposal as negotiated. Acceptability of anklet lots will be determined by the use of “Sampling Procedures and Tables for Inspection by Attributes”, ANSI 21.4, published by the American Society for Quality Control. Sampling procedures will be designated by the Government at the time of award. The sample unit is one anklet and the selection done in pairs. The anklets shall be examined for commercial type defects only.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business